Search results for "flow rate"
showing 10 items of 166 documents
Cadmium and Copper Removal by a Granular Activated Carbon in Laboratory Column Systems
2000
Single and competitive removal of Cd and Cu from aqueous solutions by using Darco 12–20 mesh granular activated carbon in column systems has been investigated. Seven experiments modifying the initial pH and the flow rate were performed. Results showed the efficiency of activated carbon as a sorbent for both metals. pH is shown to be the decisive parameter on metal removal in the column; metal removal increases when the influent pH value is raised. The influence of the flow rate for the experimental conditions is negligible. Batch adsorption and column data are compared. Column modeling assuming local equilibrium and rate-controlled pore diffusion was performed.
Adaptive PI Control of Bottom Hole Pressure during Oil Well Drilling
2018
Abstract In this paper, we studied the bottom hole pressure (BHP) control in an oil well during drilling. Today marginal wells with narrow pressure windows are frequently being drilled. This requires accurate and precise control to balance the bottom hole pressure between the pore and fracture pressure of the reservoir. This paper presents three control schemes to stabilize the BHP prole, including proportional-integral(PI) control, PI with feed-forward control and adaptive PI with feed-forward control. The proposed schemes are carried out through simulations on a high-fidelity hydraulic drilling simulator for flow rate changes and BHP set-point changes. In fast set-point changes and flow r…
Source shape and data analysis procedure effects on hydraulic conductivity of a sandy-loam soil determined by ponding infiltration runs
2017
Performing ponding infiltration runs with non-circular sources could represent a good means to sample completely an area of interest. Regardless of the shape of the source, predicting the expected reliability of the collected data by infiltrometers should facilitate soil hydraulic characterisation and also allow a more conscious use of the field data. The influence of the shape of the infiltration source (i.e., circular or square) and the analysis procedure of the steady-state infiltration data on the saturated hydraulic conductivity, Ks, of a sandy-loam soil was tested in this investigation. Circular and square surfaces sampled with the pressure infiltrometer (PI) yielded similar estimates…
Salivary characteristics may be associated with burning mouth syndrome?
2020
Background Burning mouth syndrome (BMS) it is characterized by burning and uncomfortable sensations with no clinical alterations or laboratory findings. The evaluation of the salivary characteristics of people with BMS can help the understanding of the pathogenesis of this condition. This case-control study aimed to trace the salivary profile of women with burning mouth syndrome (BMS). Material and Methods 40 women with BMS and 40 control women were recruited. Unstimulated salivary flow rate (uSFR), pH, salivary cortisol levels, salivary viscosity, and oral health impact profile (OHIP-14 questioner) were determined. P< 0.05 was considered statistically significant. Results For uSFR, mean va…
Numerical and experimental MHD studies of Lead-Lithium liquid metal flows in multichannel test-section at high magnetic fields
2018
Abstract Numerical simulation and experiments have been performed at high magnetic fields (1–3T) to study the MHD assisted molten Lead-Lithium (PbLi) flow in a model test-section which has typical features of multiple parallel channel flows as foreseen in various blanket module of ITER. The characteristics Hartmann number of the presented case study is up to 1557 which is relevant to typical fusion blanket conditions. Symbols B0, a, σ, μ in the definition of Hartmann number are strength of the applied magnetic field, characteristic length scale which is half the channel width parallel to the magnetic field, electrical conductivity and dynamic viscosity of PbLi respectively. Flow distributio…
Origin and correction of the deviations in retention times at increasing flow rate with Chromolith columns.
2010
Chromoliths can be used at flow rates beyond those feasible for conventional microparticulate packed columns. Ideally, the plots of the retention time versus the inverse of delivered flow rate should exhibit y-intercept of zero. However, significant positive deviations correlating with the solute polarity were observed for several compounds chromatographed with a Chromolith column, owing to the increased system pressure. Consequently, the dead time marker exhibits a smaller deviation, making the retention factors depend on the flow rate. Chromoliths are made of a silica-based monolith encapsulated within a PEEK tube, and should suffer larger stress with pressure than stainless steel columns…
New considerations for modelling a MED-TVC plant under dynamic conditions
2019
Abstract The multiple-effect distillation (MED) technology is nowadays the most promising desalination process to be coupled with variable heat sources, thus leading to a more sustainable way to produce water. In order to prove the potential of this, it is of major interest to develop powerful modelling tools to predict the performance of this coupling. Only a few models have been presented so far. They show promising results but were based on some simplifying assumptions and non-physical constraints that could limit the analysis of the dynamic behaviour of a MED plant. This paper presents new considerations for the dynamic modelling of a MED plant associated with a thermal vapour compressi…
CO2flux measurements in volcanic areas using the dynamic concentration method: Influence of soil permeability
2006
[1] In order to evaluate the influence of soil permeability on soil CO2 flux measurements performed with the dynamic concentration method, several tests were carried out using soils characterized by different permeability values and flow rates. A special device was assembled in the laboratory to create a one-dimensional gas flow through a soil of known permeability. Using the advective-diffusion theory, a physical model to predict soil concentration gradients was also developed. The calculated values of CO2 concentrations at different depths were compared with those measured during the tests and a good agreement was found. Four soils with different gas permeability (3.6 × 10−2 to 1.23 × 102…
A semi-empirical approach for predicting two-phase flow discharge through branches of various orientations connected to a horizontal main pipe
2010
Abstract The subdivision of two-phase flow in branching conduits consisting of a large horizontal main pipe with upward, downward, or lateral branches of reduced diameter is of great interest in various technological fields. For example, these conduits are important in light-water nuclear reactors (LWRs) in the case of a small break loss-of-coolant accident (SBLOCA) in a leg of the reactor's primary coolant loops, as well as for breaks or valve malfunctions in a large pipeline. In these kinds of circumstances, the relevant phenomenology often involves phase stratification coupled with possible liquid entrainment or gas pool-through phenomena. Therefore, these phenomena were studied in depth…
Flow hydraulic characteristics determining the occurrence of either smooth or abrupt sewer pressurization
2014
Laboratory experiments showed that pipe pressurization consequent on a drastic reduction in the downstream discharge can occur either by a gradual rising of the free-surface (“smooth” pressurization) or by propagation of a front filling the whole cross-section (“abrupt” pressurization). This study examines the free-surface flow characteristics that determine smooth or abrupt pressurization pattern through a theoretical approach using dimensionless variables. A critical flow rate value, which separates the pressurization patterns, exists for any given pipe diameter. For flow rates higher than this specific value, only abrupt pressurization occurs. For lower flow rates, either smooth or abrup…